WTB rear spindle spacers

[68rat]

Hi all, need some rear spindle spacer, could send back what I don't need.
Or does anybody know where I could get some from in oz before I order some from USA .

[bfit]

See the add on the bottom of this page,
 I think  he will have what you want
( support those who support us )
Bfit

[68rat]

Thanks for that, i called today and he might have some laying around I just need to measure what i need

[68rat]

I used the ones that came out of the left side and got it down to .04mm, i think that is about 0.00157480315 inch.

Do you think that will do (dry no grease)

[bfit]

sound like you achieved  a good result
Bfit

[68rat]

I measured the other side and got the shim from the left, and that is 3.20mm and ended up with 0.10 end play SOOO if i try and get the #3 shim that is 3.38 and skim that down. How does that sound as a plain?

[bfit]

Mate
There is no problem  machining the shim
find some one how has surface grinder to get a decent parallel shim
where  are you located
As I remember it the tolerance is 0.003" to 0.008"
some people say 0.0 to 0.003"
I don't think I would be to worried about 0.1mm 0.004"

you could try lapping  all the surfaces  of the spacers you might just  close the tolerance up
if you don't have lapping compound  use 400 wet n dry backed up with a piece of glass
 
Bfit

[Scott]

Any diff shop should be able to skim a shim for you.

[sirfixalot]

How thick is the one you need in thou

[sirfixalot]

If you have 3.20 mm shim with 0.10 end float you need to decrease shim to  3.10mm to get zero end float. 3.38mm will give you 0.28 end float

[68rat]

Bugger, i went the wrong way and Scott from the supporter from the add below is sending me one that is going to be way to big, more than .5 mm.
He did have one smaller but it is on my work email, i will check first thing. I think he said he had one that was 3.18

3.10 millimetres = 0.122047244 inches or 3.10 millimetres = 122.047244 thou

[68rat]

Scott from Corvette Alterations is sending both shims, so all sorted.

On a side note the RH side was completed last light