Restoration & Modification Projects > Restoration Projects
71 rebuild
wabco40:
I decided to finish pulling the diff this morning. The job took less then an hour from start to completely out.
It helped using a hoist and having previously fitted new bushes in the diff cross member.
I have got WA Diff Centre to fit the new crown wheel and pinion. I'll fit it back in when I return from work next week.
wabco40:
The old 3.36 gears out and new 3.90 fitted.
The diff back in and all buttoned up.
Jethro:
Brad, what Penrite product did you use ?
bfit:
Brad
The 3.9s will,give you better acceleration
I'm running 4.11 lots of go and lot of rubber burning is your nott careful.
Bfit
wabco40:
--- Quote from: Jethro on September 27, 2014, 03:31:07 PM ---Brad, what Penrite product did you use ?
--- End quote ---
Jethro, I used their 80w-90 gear oil.
I also purchased their limslip additive. I didn't know until I got the oil home that it already had the correct dosage of additive in the gear oil, so I didn't end up using the limslip.
The diff takes about 2 litres.
http://www.penriteoil.com.au/pis_pdfs/GEAR%20OIL%2080W-90%20AUGUST%202013.pdf
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version