« previous next »
Pages: [1]   Go Down

Author Topic: Small lathe Job  (Read 3898 times)

0 Members and 1 Guest are viewing this topic.

Offline 76Vett

  • Four Barrel
  • ***
  • Posts: 58
  • From the Shire
  • Location: Menai, NSW
Small lathe Job
« on: June 08, 2014, 10:24:21 AM »
Hi All. Does anyone have a metal lathe and can do a small turning job for me OR can recommend a small engineering company, not to far from the shire.
Thanks, Allen
Logged
The answer really is 42

Offline sirfixalot

  • Fuel Injected
  • *****
  • Posts: 701
  • Committee Member & Tech Adviser C3-C4
  • Location: Gods Country Sutherland S
Re: Small lathe Job
« Reply #1 on: June 08, 2014, 02:09:00 PM »
What do you need can probably do it for you
Logged

Offline 76Vett

  • Four Barrel
  • ***
  • Posts: 58
  • From the Shire
  • Location: Menai, NSW
Re: Small lathe Job
« Reply #2 on: June 08, 2014, 02:58:36 PM »
Hi Geoff. On the standoffs for my wheel spinners (center caps) the thread is too long so the spinners do not go on all the way, about 2 threads showing, see attached photo. I just need these couple of extra threads turned off, I could hacksaw them of but turning them off would be cleaner.
Thanks.
Logged
The answer really is 42

Offline bfit

  • Don't talk of dust and roses
  • Global Moderator
  • Supercharged
  • *****
  • Posts: 2878
  • Two one thousands
  • Location: NSW
  • Mood: Honey reinforced
  • Car: Yes
Re: Small lathe Job
« Reply #3 on: June 10, 2014, 10:15:11 AM »
mate
contact me re machining
Bfit
Logged
I have seen too many instances where people continue to pursue wrong courses of action because they do not take the time to think critically about what has happened in the past.’’
Winston Churchill

Offline 76Vett

  • Four Barrel
  • ***
  • Posts: 58
  • From the Shire
  • Location: Menai, NSW
Re: Small lathe Job
« Reply #4 on: June 11, 2014, 07:51:42 PM »
Thanks, all for the offers I will be in touch.
Logged
The answer really is 42
Pages: [1]   Go Up
« previous next »