NSW Corvettes

Technical Tips => Body Parts - Bodywork - Paint => Topic started by: jolinari on July 19, 2006, 11:44:50 PM

Title: SIDE PILLARS INSTALATION
Post by: jolinari on July 19, 2006, 11:44:50 PM

(http://i24.photobucket.com/albums/c25/jolinari/IMGP0856copy.jpg)

Title: SIDE PILLARS INSTALATION
Post by: smokem on July 19, 2006, 11:58:51 PM

Think you then lift up and out as bottom is forced into top of dash where it locates by design.

Title: SIDE PILLARS INSTALATION
Post by: jolinari on July 20, 2006, 12:04:44 AM

Quote

Originally posted by smokem
Think you then lift up and out as bottom is forced into top of dash where it locates by design.

Tried to remove it by force but would come out...and thats y i posted it here whether there is any special trick

Title: SIDE PILLARS INSTALATION
Post by: smokem on July 20, 2006, 12:21:31 AM

No fancy method, maybe there is some sealer behind so just move around .

Title: SIDE PILLARS INSTALATION
Post by: jolinari on July 20, 2006, 12:27:29 AM

Quote

Originally posted by smokem
No fancy method, maybe there is some sealer behind so just move around .

will give it a go tomorrow...;48

Title: SIDE PILLARS INSTALATION
Post by: MADLT1 on July 20, 2006, 03:29:11 PM

(http://i78.photobucket.com/albums/j96/MADLT1/itsme001.jpg)

Title: SIDE PILLARS INSTALATION
Post by: MADLT1 on July 20, 2006, 03:37:58 PM

hello joe,hope that helps,they should just come off with a little force,once the screws up top are out the side pillar needs to be pulled away from the frame by about a inch,thats were 3and 4 are together,its like velcro,then as you can see there is a fastener at the bottom,slide the pillar up and out with a bit of a wiggle,you will get there,good luck...........:24

Title: SIDE PILLARS INSTALATION
Post by: jolinari on July 20, 2006, 04:06:28 PM

Great info Mad! thanks Heaps ur the man!

Title: SIDE PILLARS INSTALATION
Post by: MADLT1 on July 20, 2006, 06:12:10 PM

no probs joe  :drink