NSW Corvettes
General Discussion Area => General Chat => Topic started by: bfit on May 12, 2020, 03:56:55 PM
-
Would there be any member who has a VF 2 HSV with LSA engine. Manual transmission would be good.
Or anyone who has AN LSA in standalone configuration.
I'm looking for a photo of the OBD2 connector to see what pins are used.
If anyone can assist I would appreciate the help.
Bfit
-
Must have been a Very Hot buy Bfit, sounds like it was hot enough to burn the plugs and connectors off. !?!?!
-
nothing between the turret and the floor pan is usable.
The clove box was melted / burned remains laying on the floor , however the owners manual survived with a little scorching.
other than that I have some good GTS panels to sell.
Bfit
-
Maybe also try the HSV Owners Club.
-
If it's the OBD2 connector under the dash it would have to be a standard layout/pinout for the diagnostic tool to connect. I'd be searching the webs
https://components101.com/sites/default/files/component_pin/OBD2-Connector-Pinout.png
-
If it's the OBD2 connector under the dash it would have to be a standard layout/pinout for the diagnostic tool to connect. I'd be searching the webs
https://components101.com/sites/default/files/component_pin/OBD2-Connector-Pinout.png
I thought the same however GM depending one what other controls are used use different pins.
In the Camaro 2010/15 the pin out is 1,4,5,6,12,13,14,16. I think the Australian version would be the same but need to be certain.
Bfit