NSW Corvettes
Items for Sale by Club Members & Friends => Wanted to Buy => Topic started by: sirfixalot on July 21, 2021, 10:17:44 PM
-
After a r/hand yolk that goes into diff Dana 36. I believe L & R are different lengths. If anyone can confirm?
-
In 87 GMSM on page 4B-2 Rear Axle the picture shows part 33 designation on the LH & RH Yoke Axle Shafts
I would assume since both LH & RH are numbered the same, then ergo they are interchangeable.
But I'm not the best when assuming stuff.
HOWEVER, after sitting on this section I can see on 4B-11 a note about the lengths as 7.875" and 8.5" .
Model 36 and Model 44 respectively and they should have a metal tag c/w numbers.
I hope the above helps, diffs are not in my vocabulary .
-
So Doug you are saying Dana 36 are 7.875" and Dana 44 are 8.5". I saw on one of the parts suppliers L & R axles had a different part no