Items for Sale by Club Members & Friends > Wanted to Buy

WTB rear spindle spacers

<< < (2/3) > >>

68rat:
I measured the other side and got the shim from the left, and that is 3.20mm and ended up with 0.10 end play SOOO if i try and get the #3 shim that is 3.38 and skim that down. How does that sound as a plain?

bfit:
Mate
There is no problem  machining the shim
find some one how has surface grinder to get a decent parallel shim
where  are you located
As I remember it the tolerance is 0.003" to 0.008"
some people say 0.0 to 0.003"
I don't think I would be to worried about 0.1mm 0.004"

you could try lapping  all the surfaces  of the spacers you might just  close the tolerance up
if you don't have lapping compound  use 400 wet n dry backed up with a piece of glass
 
Bfit

Scott:
Any diff shop should be able to skim a shim for you.

sirfixalot:
How thick is the one you need in thou

sirfixalot:
If you have 3.20 mm shim with 0.10 end float you need to decrease shim to  3.10mm to get zero end float. 3.38mm will give you 0.28 end float

Navigation

[0] Message Index

[#] Next page

[*] Previous page