Technical Tips > Brakes, Suspensions, Steering, Wheels & Tyres

Wheel alignment issues

(1/2) > >>

anychevy:
Just replaced the front lower control arm bushes and ball joints and found I can only get ~ 1.5○ + caster without going into + camber and there's no room for more shims.
I read on corvette forum alot of guys "slot" the shaft for fore and aft movement and there is also a MOOG kit for added camber which also allows for more shims.
Has anyone tried either of these, or have another solution ?
I've got very little wheel return out of a corner now.

bfit:
Mate 
72vet will see your post
 he has or had a spare set of offset
top brackets the allows for more adjustment
you mate consider  a spreader bar across the top of your spring towers
Bfit

anychevy:
I think this is what I need, but I'm not sure if this is the MOOG version or Van Steel's ?

 

bfit:

--- Quote from: anychevy on October 05, 2012, 03:52:02 PM ---I think this is what I need, but I'm not sure if this is the MOOG version or Van Steel's ?

 




--- End quote ---

I think you will find this is the still of bracket  72Vet has ( or had a few months back left of from his rebuild )

anychevy:
OK, great, I hope to hear from him.
Thanks
Dave

Navigation

[0] Message Index

[#] Next page