Restoration & Modification Projects > Modification Projects

6 speed Magnum in to C3

(1/3) > >>

bfit:
A few photos of mount  to fit Tremec 6 Speed magnum in to early C3



end view of plate the welds to chassis



chassis mount on cross member
Mount weld in original  position  as original  cross member







Trans mount  is positioned 25 mm forward and 20mm lower that the origin mount on the cross member





It a pears that a transmission guard will be needed as the transmission will be lower  that the  bottom of the cross member .

Andy  
I think I am on top of the swap  
keep you posted

Bift

sirfixalot:
Will look like a factory x-member to the untrained eye.
Subtle changes that incorporate improvements has got to be good

69 DIRTY RAT:
Good job!

bfit:
the process continues

Gear  box as it arrived


Trany with Bell housing
I have the box

First problem is the speedo drive points the cable straight at the exhaust.

I am not in the process of shorting the drive out of the box,
  to allow the use of a 90 deg  drive .
With the cable drive as supplied the 90 Deg cable drive will not fit
It interferes with the mounting  pad of the transmission.
Bift

Jethro:
Hey Rob,

Doesn't the new 6 speed box have the alternative to run electrical speedO as well as the traditional mechanical?

Navigation

[0] Message Index

[#] Next page