Technical Tips > Brakes, Suspensions, Steering, Wheels & Tyres

replacing hand brake handle

(1/2) > >>

69MLC:
hi all, any tips on replacing a 69 hand brake handle? looks to have at base one steel pin. Is this just tapped out? any feed back on proper percedure would be appreciated . regards murray

bfit:
mate
 I will dig my 69 service manual out tonight and copy relevant  section
If there is one
Bfit

bfit:
It  looks like a roll pin
I have not  looked at manual as get
But I would make a puller  
 if that hole  goes rite through
get a bolt that fits  that you can  slide a piece of pipe over
YOU will need some washers  
 and a nut on the other end and tighten slowly and see if it moves
NO hammers    if possibly
be back to you on this

I have a 69  I will be working on tonight I may be able to help tomorrow
Bfit

 

69MLC:
thanks Bfit

72vet:
Hi Murray, this might help. Had to take the pages with the camera, my scanner decided to have a dummy spit for some reason. :beer:

Navigation

[0] Message Index

[#] Next page