Author Topic: 1969 Rear Emblem Drilling Template (Read 6901 times)

Norms 69 Vet · « **on:** May 22, 2011, 05:45:38 PM »

I am at nearing the end of my restoration and need to fit the rear CORVETTE emblem.

Does anyone know where I can get a templete showing the drilling layout.

Camo · « **Reply #1 on:** May 22, 2011, 05:54:06 PM »

Welcome to the site.

I'm sure one of the lads will chime in when they come on line.

If not Scott from Corvette Alterations (Club Sponsor) may be able to help you out. His details are at the bottom of the forum

72vet · « **Reply #2 on:** May 22, 2011, 06:09:32 PM »

Welcome to the Forum,

What’s your location in Aus? My car is at the panel shop having a few repairs; if you like I can make a template and send it to you.

sirfixalot · « **Reply #3 on:** May 22, 2011, 09:03:23 PM »

Make one using a compass & cardboard trial fit badge pins to template then put masking tape on filler lid & transfer hole positions off template to filler lid

Norms 69 Vet · « **Reply #4 on:** May 23, 2011, 07:52:55 PM »

Hi 72 Vet\\I am located in Sydney, I have not attended the meetings for a while, but will be at the next meeting, so if not too much trouble that would be much appreciated.

72vet · « **Reply #5 on:** May 23, 2011, 07:58:24 PM »

Hi Norm,

I’ll have it for you at the next club meeting.

Norms 69 Vet · « **Reply #6 on:** May 24, 2011, 08:16:10 PM »

Hi 72 Vet

Thank you for that, will see you then.