I have finally found some time to do some more work on the car. However things seem to be going backwards at the moment.
I have been trying to get the top windshield moulding to sit flat on the glass as it tends to blow out where it curves around at the ends. The windshield is bonded about 7-8mm out from the pinchweld so it not a case of being set too deep. Also while I was removing the top moulding the clip release tool I was using caught the edge of the glass and cracked the screen:grr:
Another new windshield bonded in place however this time I blacked out the edges so the urethane is not visible. Also after much bending and twisting got the moulding to sit closer to the glass. Its still not perfect but will have to do.
I previously rebuilt the wiper door linkage.
The problem is when I went to install the wiper door unit the right wiper arm is hitting the underside of the door :banner:
I had replaced the wiper arms with later model arms that the vender said would fit. I think its another case of reproduction parts not fitting correctly.
The picture shows the repro (black) and the original arms. The repro arm has too much of a bend at the end causing blade to touch the left blade and not allowing the right blade to park low enough at the base of the screen. I check US forums and it seems even correct year reproduction arms have this problem. I plan on cleaning up and using my original wiper arms.