Restoration & Modification Projects > Restoration Projects
71 rebuild
Jethro:
Wabco,
Where did you end up getting power window kits from?
Jethro
wabco40:
--- Quote from: Jethro link=topic=7864.msg1045941278#msg1045941278 ---Wabco,
Where did you end up getting power window kits from?
Jethro
--- End quote ---
Jethro,
I purchased it from Corvette Central a few years back.
They just put together all the standard power window parts (regulators, motors, harness, switches and conduits etc) and sold it as a power window conversion kit.
I think I paid $600-$700 for it.
I have also got new door panels so there will be no hole where the handle used to be.
Jethro:
Seriously thinking of doing the same
wabco40:
I have fitted the left lower dash.
I also replaced all light bulbs, light switch, vacuum solenoid and speedo/tach cables.
Its quite easy to install without the windscreen and top dash pad fitted. I would hate to try do it with them in place!!!
I have also fitted the rear window seal and removable window.
wabco40:
I have got a bit more work done.
I have glued the door weatherstrips in place. The doors are very tight to close at the moment however I am expecting the weatherstrips to compress over time.
I have also buffed and fitted the SS moulding and fitted a new outer window seal to the door.
I finally got around to finishing off the seat belt installation. Thanks Geoff.
I still need to fit the rear quarter trim pieces and I also have some 74 retractor covers and covers for the top brackets.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version