Technical Tips > Radiators - Cooling

Aluminium or Copper/Brass Radiator

(1/3) > >>

Reklaw:
Now that my long term '75 project is driveable, the inevitable teething problems are starting to show. The latest is its habit of overheating, at low speed, doing 100 on the open road etc.
The usual things have been covered, seals around the radiator, spoiler underneath, 160 thermostat (must get a High Flow, thanks Demonx) etc. Running a standard fan with standard shroud. The pump impeller looks OK, so I'm discounting the pump so far. The radiator is a bodgie, requiring a made up lower hose, so I'm considering my options with a new radiator.

I've read a lot about aluminium radiators being more efficient that copper/brass, but those articles are usually written by people who make/sell aluminium radiators.

Does anyone have any advice to offer regarding their experiences with aluminium vs copper/brass radiators. And ........... No, I'm not about to reopen the great debate on thermo fans vs standard setups.

BOSCHVETTE:
ALUMINIUM HANDS DOWN.
and by the way thermos are better too.
and check your timing get it on a dyno it is worth every cent.

demonx:
Fix up the hoses first. You'd be best to do that if you buy a new radiator anyway.

If that does not solve the problem, get the radiator pressure tested & professionally flushed. It might be not 100% and that can make the world of difference.

My '76 used to over heat and I'd have t pull over etc, all I did to fix it was new thermostat (160 high flow) and the pro flush and pressure test. Car never overheated after that.

Also - about the thermo's - not for a C3. With the original cowl setup etc, removing that and putting thermo's on can have a negative effect. I looked into that when I first got my '76 and was very quickly persuaded otherwise by those in the know.

Hope that saves you some cash. If not maybe you do need a new radiator. The pressure test will confirm this if it does.

Reklaw:
Thanks for the info. Boschvette & Demonx.
Things took a different turn today. The car was at a place to have the discs machined. I happened to mention to the guy about the overheating problem. He went & found his Non Contact Laser Thermometer and pointed it all 'round the engine. That thing showed temps about 20 degrees (C) lower than the gauge. I then went to Dick Smith's and bought a cheapie for $49. See picture below. Same result. Bottom line is the cooling system is working reasonably well, but the new VDO Gauge or Sender is crook. So much for good German technology. The Non Contact Thermometer is a good thing, can be used for exhaust pipe temps, hub temps etc. Might be worth the investment.
BTW, Tridon make a high volume Thermostat, part # TT2000-160. I have one on order from Repco at the moment.

MADLT1:
on my vett i run a harrison alliminium radiator with the standard shroud and fan set up,plus twin thermos.i placed the thermos in front of the radiator support panel,they fit really snug,the engine runs about 180 on the hottest of days.

Navigation

[0] Message Index

[#] Next page