Technical Tips > Interiors - Trim - Seats - Carpets

Vacuum molded interior/dash - anybody had this done?

<< < (2/2)

MADLT1:
i have had my interior dyed as well,i thought it came out pretty good

WARFARIN:
Chromie is spot on [again!]
The shrink on cover looks fine; but it adds a thickness of dash material. Your speaker grilles and demister vent at the top will not fit the same. Similarly you will have problems with side vents and the centre instrument cluster.
Good luck!
David

TPI-383:
A mate of mine had a XT Falcon dash done by a place in Sydney, not sure of the name.When it came back it was like brand new. They stripped the old skin and repaired the foam underneath before reskining (vac moulded) the dash so it was not thicker and everything fit great. I will try and chase up a name and no. if you like. I would not hesitate to use them for my car.
Tim  

demonx:
TPI-383: thanks for the info but if I decide to go this route I'd be going with someone in Melbourne/Geelong/Ballarat area. I'd rather not have to send everything up to Sydney..

77CVT:
This place is good but may be too expensive - Modicoat

Navigation

[0] Message Index

[*] Previous page