Technical Tips > Pre 84

69 Master cylinder bore size?

<< < (2/2)

77CVT:
How did you get the Wilwoods to fit on the back? (are they Dynalite's?)

I have drawings to make a bracket for the front calipers but not to fit the back.

69 DIRTY RAT:
Got them from http://www.hotrodsusa.com/ they make sets up for C3's. They are dynalites! I should have traced the brakets before puttin them on!

69 DIRTY RAT:
FIXED!
I havent driven it yet,and you probably wont believe me but once the proportion valve went in the problem was fixed!
It was just getting to much fluid/pressure to the back causing it to lock up. Once the pressure from the back was eas'd more fluid went to the front and now works perfect (apparently)!

77CVT:
What piston size do the C6 calipers have?  They were probably near the same as the C3's.

Good to hear it is sorted.  Did you get the adjustable one so you can spare the rear brakes for the burnouts?  ;46

69 DIRTY RAT:
Not sure the C6 bore size....I think it was in all that info you gave me somewhere?
Yes I put the bias valve in so I can now wined the bias to the front and do somemore burnouts without hurting the brakes to much...although I think I'll get a line locker at some stage.

Navigation

[0] Message Index

[*] Previous page