Technical Tips > Pre 84

It starts here I think

(1/2) > >>

jdunne:
Does anyone remember where there was an article on replacing the headlight vacuum actuator rod seals with the how to pictures.....i read it somewhere but my memory fails me......not surprising since my headlights are failing me too......john:22

david_moore:
Gyday John,
Pretty sure it was in Vette magazine, if pressed I could probably find it for you. ;29

Brutus:
John, I'll see if I can chase up the rest of this series for you.
http://www.vetteweb.com/tech/0212vet_intothevoid/
http://www.vetteweb.com/tech/0303VET_VacuumSys/

Scott81:
John,

This is a pretty easy job to do, the hardest part is getting the actuators out.  There is a small ring with tabs on it holding the outer seal on, use a small jewelers screw driver to carefully bend the tabs up.  Other than that it's a no brainer....it has to be since I could do it without anything exploding.

Brutus:

--- Quote ---Originally posted by Scott81
John,

it has to be since I could do it without anything exploding.
--- End quote ---

;laugh:b2:22

Navigation

[0] Message Index

[#] Next page