General Discussion Area > Corvette Related Chat

Ecklers

<< < (2/2)

RHD.68.l89:
No, it was definitely Ecklers and it was probably Pre Debby. Haven't bought anything from them in over 10 years because they used to charge this fee when every one else just charged exact costs. They were the only ones with the part I required and it was the first and only time I bought anything from them.
If they have fallen in line with the rest of the vendors I might try them again but I currently use Connell when I need something.

reserved:
:b4:b4:b4:b4
I am new to this importing small packages, so the following could be a load of crap but I believe it to be factual.
Ecklers do not seem to like sending goods by the postal service. But they have the best range of parts I've seen to date and the club members get a good discount.
I have just ordered some parts including an exhaust manifold, which if sent USPS surface mail would cost around $60 in freight, surface mail is OK I'm in no hurry and 6weeks delivery is fine. I cann't wait to find out the actual cost is going to be.
Using USPS the weight limit is 22KG and typical box sizes could be 400x400x400mm or
1000X300x200mm or 600x500x200mm or 800x500x100mm almost(but not quite) door trim panel size and costing probably $30.These sizes are quite generious and would be big enough for most requirements.
The maximum allowable size of the package using USPS dimensions is found using the formula girth + length=2000mm.
I will be pushing for all my future deliveries to be sent by USPS surface mail. Unless I require the parts in a hurry.

;42

Navigation

[0] Message Index

[*] Previous page