Technical Tips > Electrical-Electronics-Air-Lighting-Guages-Security-Vacuum

HEADLIGHTS C4

<< < (3/3)

SC:
you can use a 25 mm nylon bar and cut it into sections 25mm long it does the same job and is a lot cheaper

coradict72:
SC  your right the expense of buying the correct replacement bushes is expensive I just hope to pass on  the vette in a manner I'd expect if I was searching for a good beast.My other point was Chev parts did me no favours as a nswcu member

BOSCHVETTE:
i took a picture off the net and scaled the rods off that and made them out of brass oiled them and they have been in my car for 4 years now with no problem.i also have put them in about 8 other vettes with no problems.cost about 3 dollars a car and you can get from any model shops.

Navigation

[0] Message Index

[*] Previous page

Go to full version