Items for Sale by Club Members & Friends > Wanted to Buy

C3 seat frame with seat belt holes

<< < (4/6) > >>

Ollie68:

--- Quote from: Bfit on October 09, 2018, 08:07:39 PM ---If you need a pair of seats I have two out of a 70 model.
I’ll post a photo tomorrow to show you how my lap/sash  seat belts look
Bfit

--- End quote ---
I have a pair of seats that are out of the car but the seat belts that have been supplied are designed to go through the seat, not around it.
Its not uncommon for the seat belts to go through the seats.

Ollie68:

--- Quote from: sirfixalot on October 09, 2018, 02:34:43 PM ---I have a solution for mount on pillar using the belts you have if that will work for you

--- End quote ---
Id be keen to have a look at it?

bfit:
I think you could argue, to only have a lap belt , fixalot would know about that.
Your pre 72 a lot depends on who does your blue slip and their knowledge of the laws.

Even though you say your car is a 71 model if it was manufactured in 1970 , like a lot of 71 models were, by Australian law the car is a 1970 model .if manufactured in 1970.
This is an important fact when you are arguing  your point at registration time.
Bfit

Ollie68:

--- Quote from: Bfit on October 09, 2018, 09:44:12 PM ---I think you could argue to only have a lap belt , fixalot would know about that.
Your pre 72 a lot depends on who does your blue slip and their knowledge of the laws.
Bfit

--- End quote ---
Not a hope down here in Mexico ( Vic )
Its has to have lap sash inertia belts.
Pre 68 no worries but anything from Jan 1 1969 and its gotta meet the ADR's.

bfit:
I’ll get you a photo of my set up. It’s a variation on fixalots method
If your handy with tooling it’s not hard to make it look stock.
I personally don’t like the anchor point on the rear lounge compartment floor.
Mine is mounted on the bottom of the pillar .
A photo is worth a thousand words as they say.
Tomorrow
Bfit
Ps fixalot can supply you a kit do do the job

Navigation

[0] Message Index

[#] Next page

[*] Previous page