Technical Tips > Interiors - Trim - Seats - Carpets

Changing seats in a 69

<< < (3/3)

Lefty:
Geoff,
Did you pack the front or the rear of the rails up, or both?
Best
Lefty

sirfixalot:
Depends which way you want the seat to tilt I use a washer 50mm in diameter 1.5mm thick under seat feet they have a 5/16" hole.They are washers from child restraint anchor bolts. I have them here if anyone needs some. 3mm at the floor at rear equates to a big change at top of seat. I also fit a 5/16 UNC x 1 1/4" bolt to rear anchorages from under car makes it a lot easier  to fit the seats & packing washers, then use a nut & washer on top side of seat mount. C4 seat mounts went this way.

Navigation

[0] Message Index

[*] Previous page