Technical Tips > Post 84
87 C4 Leaks - but different leaks.
Vettech:
Yes - steel bolt thru alloy pump, threads screw into cast iron block, and above the "nut", a clean bolt shaft then goes thru the alloy A/C mounting frame, then the last threaded bit has washer and nut. Its a rod threaded each end with a nut "head" in approx the centre. Two of, one longer than the other. But both require a long socket, which also allowes the bolt to go thru. Some cheapo sockets only have a small hole thru them.
No the "Release Lube" is very old, inherited from my father, and he's been gone since ~ 2000.
MY081:
Mmmmm Mapgas Torch , Fuel Line !!!!! Should we be looking for a new Treasurer .
bfit:
Insurance ? Job
bfit:
I have an ls1 that would fit in there
Kenobe:
Penetrene spray over night, a good hit on the head is possible or heat the nut and allow to cool, don't try to undo it hot.
And Bob what are you doing using KY? :banana: :banana:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version