Technical Tips > Body Parts - Bodywork - Paint

C4 Halo/Roll bar, body packing.

<< < (2/3) > >>

bfit:
its a Bosch produce , looking for a part number
Bfit

Vettech:
Been surfing the net - plenty of adhesives from LORD AND 3M 8115 or 8116 but are two pak and more glue than bulk filler. Ummm...

bfit:
The product I'm thinking of is normally used in expansion joint in block and panel construction .
Bfit

69VETTE:

Hey guys, your probably thinking of Sikaflex... ??? Try www.ovesco.com.au. They have them all with information on uses..   I think the one you need is the Sikaflex - 255Extra

Check it out.. good luck

Vettech:
Thanks Bfit, your pic and that of 69vette of the sikiflex 255 are the type but I dont think either are for large voids 8 ~10mm, but I did see whilst aimlessly gooooogling a product which comes in a sausage, not sure how you apply it, but sets for high tensile, fills voids, it was glass or metal reinforced, I just have to re-find it again. I cleaned up the sticky mess and got up close to see the rear window glass side - it also has filler that appears to be solid and in good nick. Strange the front and rear of the rollbar are bonded fglass body to steel, but the centre section of the steel is not, it has holes and forms pressed/punched in it, to give strength etc, in fact the few wires up there could run thru the voids except they are razor sharpe, its amazing how much blood can seep out of a few fingers.

Navigation

[0] Message Index

[#] Next page

[*] Previous page