General Discussion Area > Corvette Related Chat
Right to Left Conversion #2
bfit:
if you are interested ,
I have a 70 model fixed steering column that was overhauled and fitted to my 70 when I bought it.
replaced it with a tilt.
I have a stock steering box drag link, idler, pitman arm , as well if of any use to you
Bfit
70vette:
Thanks for the offer Bfit. Is the pitman arm off a non powersteer car? I already have a pitman arm and idler arm. But a non steer pitman arm would work better with the Borgasen steering box. I managed to build a steering column from the 2 tubes that i had.
bfit:
The pitman arm came with a lot I bought , I’ll see what it is tomorrow and let u know .
Your well into the column , I see .
I was checking out a hq holden column this week , I think the bottom half would work with a vette column
The hq has a collapsible section that is a better design than the vette
70vette:
Rub, rub, grind this is painfull.
Next time i'll pay the sandblaster. Quicker, faster, cheaper; in the end, ends up a better job.
sirfixalot:
Check the vacuum tank for splits in the bottom of swages have seen 2 like it. I can test it for you if needed with vacuum pump. Or immerse in water with compressed air inside
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version