General Discussion Area > Corvette Related Chat
Right to Left Conversion #2
bfit:
It wouldn't ne hard to make. I can measure one for you if that would help
Bfit
sirfixalot:
I have a piece cut for RHD steer box support it hasn't been bent yet all you will have to do is bend it the opposite way. Piece of 50 mm x 3 flat bar & an angle grinder will also do the job Make a template out of a cerial box much easier to cut & bend to get right.Rescued the AC bits for you from the departure lounge
70vette:
--- Quote from: sirfixalot on March 23, 2017, 05:51:07 PM ---I have a piece cut for RHD steer box support it hasn't been bent yet all you will have to do is bend it the opposite way. Piece of 50 mm x 3 flat bar & an angle grinder will also do the job Make a template out of a cerial box much easier to cut & bend to get right.Rescued the AC bits for you from the departure lounge
--- End quote ---
I have a similar piece welded on there for the RHD box that was on there. But trying to keep it looking original as I can. Can buy the bit from USA for $15 but seems silly by the time they stiff you for delivery and conversion to AUD you have payed $50 for 2"×2"of 3mm plate with a hole drilled in the middle of it. Let me know when is a good time to pick up those aircon bits :drunk:
--- Quote from: Bfit
link=topic=11332.msg1045958091#msg1045958091 date=1490224801 ---It wouldn't ne hard to make. I can measure one for you if that would help
Bfit
--- End quote ---
If you are taking the measurments from an original one that would be good. I could copy ot all down on a piece of cardboard and superimpose it on to some 3mm plate and fold it up and mig it on.
bfit:
I'll get it done Saturday
Bfit
bfit:
I found it easier to make the bit than draw it .
How do we get it to you
You will need to get this in the correct place ,
Does your chassis still have the original engine mounts
Bfit
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version