General Discussion Area > Corvette Related Chat
Right to Left Conversion #2
70vette:
--- Quote from: Bfit on April 13, 2018, 05:25:49 AM ---https://www.lectriclimited.com/vehiclesearch/result/index/year/111/make/21/model/65
This company get a good wrap for quality , worth a look
Bfit
--- End quote ---
Yes I've seen this but by the time it gets here landed it will cost a bit and take forever.
Went into Rare Spares yesterday at Prospect had a bit of a look. found some plugs and terminals that are the same. Also ordered some pins from Fleabay, for the plug that plugs the rear loom. Some of mine are broken and a couple of wires that should be in the plug are not. All here in OZ.
Now i think the only plugs that I need are the fan blower relay and the plug behind it. and only because they are partly melted. After that all should be ok ready to tape up. Even found the non adhesive electrical tape like factory. I have been on the net relentlessly looking for this stuff. Can't believe you can't buy it here but you can. You just need to look for it.
bfit:
Do u have a photo of the plug you need
Bfit
sirfixalot:
Fan relay has 2 plugs ?
70vette:
--- Quote from: sirfixalot on April 15, 2018, 10:13:13 AM ---Fan relay has 2 plugs ?
--- End quote ---
That's correct! One single plug and one three pronged plug. :yes:
70vette:
Anybody know where I can get Doug's side exhaust and headers here in Australia? If I am going to spend money on the exhaust I'm going the side pipe route. The headers I originally had on my car won't fit with the Borgasen box. They are more suited to rhd car. Didn't think the box was going to make that much diffrence on the left of the car.
I would consider a s/h set of lhd headers at the right money if any body has anything stashed in their shed that they may want to get rid of
Eg: Hookers etc
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version