General Discussion Area > Corvette Related Chat
Right to Left Conversion #2
bfit:
I have an A3 drawing , that a friend gave me, very handy
70vette:
What do you mean...as in a drawing of a actuall loom or the diagram as i posted earlier?
bfit:
--- Quote from: 70vette on April 02, 2018, 07:16:03 PM ---It's not that the job is difficult it's just that I have never eyeballed a standard loom so just flying blind, coupled with the fact that some plugs are missing, the loom a little butchered and not sure if I have the lengths correct. I am going up tonight to shorten the dash globes. Some of them also need replacement due to the retainers being broken. So that just means that that job won't be totally finished; and thats were the frustration lies!
--- End quote ---
Yes the metal section pulls out of the plastic , I have glued a few back together just a little silastic will work leave for a few days to cure.
Or Dorman 85805 will work. The fitting out of a HR Holden dash will work as well
If you need the two,wire one of the top middle of the tachometer I haven’t need one of those so have not looked of one
The bulbs are BA9 size , if you want to go to LED there are holder options for the T5 bulb .
I’ll take a photo tomorrow of the rear of my dash .
bfit:
--- Quote from: 70vette on April 02, 2018, 07:24:48 PM ---What do you mean...as in a drawing of a actuall loom or the diagram as i posted earlier?
--- End quote ---
A diagram .
bfit:
I recon that Phill at corvette connections just may have a standard loom.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version