Technical Tips > Engines - Carbies - Exhausts - Dissys

PS pulley hitting on front x-member

<< < (4/6) > >>

bfit:
Here you go this is the belt on one of my spares  direct drive of the crank
the bracket  is the rear mount bracket  that is bolted flush on the front of the block.
The pulley on mine pumps measures  5 3/4' OD.
Bfit

bfit:
photo of pulley
photo does not show measurement  well 5 7/8"  from  rear to front of pulley
bfit

Scott:
Looks like I have the same pump and bottom mount bracket.  I'll have to make up the top adjusting one though.  I've cut the bracket apart now, I just need to weld it back up, which means a trip to my fathers place to use the mig.  I was easier when I had it on permanent loan form him as he preferred his stick welder.  Now he's used to the mig, I don't think I'll get it back...

bfit:
when there is a little light in the shed tomorrow ill take a better photo of the adjusting bracket ,.
Bift

sirfixalot:
Bobs pulley is 5 3/4" yours is 6" will check one I have tomorrow. With a 6 " pulley won't matter how close to the block you get it will still hit the chassis cut out correct one only has about 10mm clearance tops to the chassis.

Navigation

[0] Message Index

[#] Next page

[*] Previous page