« previous next »
Pages: [1]   Go Down

Author Topic: Welding or Brazing aluminium.  (Read 3659 times)

0 Members and 1 Guest are viewing this topic.

Offline Vettech

  • Supercharged
  • ******
  • Posts: 1612
  • The rocket sled in Steel Blue.
  • Location: Cecil Hills. N S W.
  • Mood: Electrofied.
  • Car: C3 78 + C4 87 + C4 90
Welding or Brazing aluminium.
« on: September 28, 2015, 08:55:39 PM »
Welding or Brazing Aluminium !?.. I saw a u tube welding Ali sheet and parts, with Propane, the results looked good and easy to do. Has anyone done this or knows where to get it. Seems there is Muggyweld, Aliweld, durafix, SuperAlloy 5. But can't see anyone who sells them. And no I have not broken the car, I'm building a new "Yagi Antenea" for 80-108mhz.
Logged
🖕 Vettech.

Offline bfit

  • Don't talk of dust and roses
  • Global Moderator
  • Supercharged
  • *****
  • Posts: 2878
  • Two one thousands
  • Location: NSW
  • Mood: Honey reinforced
  • Car: Yes
Re: Welding or Brazing aluminium.
« Reply #1 on: September 28, 2015, 09:08:23 PM »
Not that easy
Tig is considerably easier , with better results.
In the past CIG  has  sticks to weld aluminium
Bfit
Logged
I have seen too many instances where people continue to pursue wrong courses of action because they do not take the time to think critically about what has happened in the past.’’
Winston Churchill

Offline Vettech

  • Supercharged
  • ******
  • Posts: 1612
  • The rocket sled in Steel Blue.
  • Location: Cecil Hills. N S W.
  • Mood: Electrofied.
  • Car: C3 78 + C4 87 + C4 90
Re: Welding or Brazing aluminium.
« Reply #2 on: September 28, 2015, 10:03:40 PM »
If I was 30 years younger I would lash out and buy a Tig. But these u tubes are recent and the results look satisfactory 4 what I want - some one will come out of the woodwork with some info, I'm sure.
Logged
🖕 Vettech.
Pages: [1]   Go Up
« previous next »