Technical Tips > Brakes, Suspensions, Steering, Wheels & Tyres
C2-C3 Front coil springs
77CVT:
--- Quote from: anychevy on April 08, 2014, 12:46:08 PM ---Do you remember what brand and how low ?
--- End quote ---
Can't remember what brand. You can give Fulcrum a call - http://www.fulcrumsuspensions.com.au/
The wheel arch was same height as the tyre. They did make the front end pretty stiff!
anychevy:
--- Quote from: 77CVT on April 09, 2014, 08:18:35 AM ---The wheel arch was same height as the tyre. They did make the front end pretty stiff!
--- End quote ---
Thanks for that
I picked up a used pair from Bfit (thanks again Bob) I'll clean them up and try them first.
I can always cut a little off if too high.
Cheers
77CVT:
I cut only 1/2 a coil off my 71 stock spring and they are too low! :tears:
Mind you.....you can't expect much from 40yr old springs.
anychevy:
--- Quote from: 77CVT on April 10, 2014, 08:15:38 AM ---I cut only 1/2 a coil off my 71 stock spring and they are too low! :tears:
--- End quote ---
:eek: I think we've all been there, if we're honest
This is a good article on how (and how much) to cut a coil spring
http://www.chevyhiperformance.com/techarticles/89858_chevrolet_lowering/
Jethro:
Lads I have 335 - 340 mm from centre line of wheel to top of guard can someone tell me what a standard set of stock height springs would be ? Cause I reckon my front springs have sagged as I'm scrubbing out on things I never used to... No I haven't put on fooken Weight :grin:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version